Solution: Change the computer's resolution to match the projector's resolution.
OPENSHOT SOFTWARE DOES NOT FIT ON COMPUTER SCREEN FULL
It cannot fill the full height because the projector's chip is designed for a 4x3 image. If you are projecting a 16x9 resolution, the projected image should have the same width as the projector's blue test image.On a 4x3 with computer set for a 16x9 resolution If you need to show a presentation that is in 16x9 format, use a classroom that has a 16x9 screen. There is no automated easy way around that. This may stretch some pictures in the presentation. Solution: Change the presentation's page setup (File > Page Setup > Slides sized for) to a 4x3 format.It cannot fill the full height because the projector's chip is designed for a 4x3 image and it is receiving a 16x9 image from PowerPoint. If you are projecting a 4x3 resolution but open a 16x9 powerpoint presentation in full screen, the projected image will have the same width as the projector's test image but not the full height.If you are projecting a 4x3 resolution and open a 4x3 powerpoint presentation in full screen, the projected image will have the same width and height as the projector's test image.If you are projecting a 4x3 resolution, it should match both the height and width of the projector's test image.On a 4x3 screen with computer set for a 4x3 resolution Below is what to expect when the resolutions match and don't match. At least one of them should match the projector's resolution. Check the computer resolution and the powerpoint resolution.If the neither the height nor the width are filled, the projector has been physically moved too far or too close. This is the maximum image size the projector can produce when zoomed out. Note the size of the projector's blue (test) image that appears when it first turns on.(you need the remote for this) Sometimes the projector zoom may have been inadvertently adjusted. Ensure that the projector is fully zoomed out.Note down: Is the computer connected using VGA or HDMI? HDMI will usually automatically select the correct computer resolution, whereas VGA may choose the wrong resolution.The steps below will help technical staff determine the cause and recommend a solution. So the easiest solutions will involve changing the computer or powerpoint resolution. Note that it is not possible to change the projector's resolution (without installing a new projector and a new screen, both of which are expensive and time intensive processes). There can be several reasons for this: the computer resolution and the projector resolution do not match, the powerpoint resolution and the projector resolution do not match, neither computer resolution nor powerpoint resolution match the projector resolution. So I suggest setting size and location even when you intend to open the window as maximized.It is possible that the projected image does not completely fill the screen. So the window might look good as long as it is maximized, but when restored, the window size and location can still be wrong. Note that setting WindowState to FormWindowState.Maximized alone does not change the size of the restored window. This.Location = new Point((screen.Width - w) / 2, (screen.Height - h) / 2) Int h = Height >= screen.Height ? screen.Height : (screen.Height + Height) / 2 Int w = Width >= screen.Width ? screen.Width : (screen.Width + Width) / 2 StartPosition was set to FormStartPosition.Manual in the properties window. I also center the form in the working area: public MainView() This is why you are experiencing the problems mentioned in your question.Įxample: Here is how I resize the form to a size half-way between its original size and the size of the screen's working area. Otherwise the form's own positioning and sizing algorithm will interfere with yours. If you want to set the form size programmatically, set the form's StartPosition property to Manual.
0 kommentar(er)
